1.1 xArrow SCADA 1.3.0
The Android device used to test is Huawei Honor 6+ (Android 4.4.2), it connected to the router via WIFI, and its IP assigned by the router is 192.168.1.100. The phone have already installed the xArrow SCADA APP (the apk file can be found at [xArrowAndroid Install Folder\Out\ANDROID_BIN\xArrowAndroid.apk]).

1.2 Fx3U + Fx3U-ENET-ADP
Program Software: GX Works2 1.555D

Program Cable: SC-09
The PLC connect to the LAN port of the router, its IP address of the PLC is 192.168.1.250

1.3 Router
TP-Link，Address is 192.168.1.1

Launch GX Works2


2.1 New Project


2.2 PLC Connection






2.3 Configure




2.4 Write configuration to PLC




2.5 Restart PLC
Restart PLC, and connect PLC to the LAN port of the router.
If all ok, user can ping the PLC from the computer, as follows:

3.1 Create New Project




3.2 Create Station
Click menu [Data Configuration\Station…] to create station, as follows:


Configure the protocols, as follows:



Note: This IP address is the IP of the PLC.



3.3 Configure Analog
Configure [Data Configuration\Analog…] to set analog tags, as follows:








When all the tag set OK, as follows:


3.4 Configure Switch
Configure [Data Configuration\Switch…] to set switch tags, as follows:








When all the tag set OK, as follows:


3.5 Make Drawings


Double click the widget to set its properties:




3.6 Run Emulator
Note: first close all other connections to the PLC, also including program software.


3.7 Download Project
Note: the xArrow SCADA should already started in the android phone.

Note: first close all other connections to the PLC, also including program software.